Where to Buy
380 44 353 92 42
UA
About company
Products
Antenna and Cable analyzers (VNA) Antennas Software-Defined Radio (SDR) Amplifiers Power Supply Mobile Radio Batteries Transceiver interfaces (TI) Kits Tokenblauser GPSDO REAMP Power logger Software Cables&Connectors Accessories Discontinued products
Support Service Tech Blog
Where to Buy
RigExpert WTI-1

RigExpert WTI-1

Connect your transceiver to the Internet via a Wi-Fi network. Use your laptop to operate phone, CW or digital modes from anywhere in the world! The following resources are available on-line:

To connect the WTI-1 to your transceiver, you will need a special cable. Fortunately, pre-built cables for many transceivers are available. Moreover, you may construct a cable yourself, using the diagramspublished on our website. Please make sure to update your WTI-1 to the latest firmware and use the latest version of the ShackLink software on your PC. A number of user’s guides provide step-by-step instructions of how to set up and operate your WTI-1 device. The guides are available in the PDF format at the Downloads section:
  • The Quick start guide describes in a short form how to quickly set up your WTI-1 device to start operating.
  • The User’s manual contains more detailed instructions and examples of the use.
  • The ShackLink software manual describes the ShackLink program deeply, so operating becomes easy even for an inexperienced user.
  • The Software setup examples will help you quickly set up your favorite software to operate digital modes via the WTI-1. Many other programs are supported, although not included in this manual.
  • Remote operation becomes easy with the Operating via the Internet guide.

RigExpert WTI-1
Specifications

RigExpert WTI-1
General features
  • CAT (Computer Aided Transceiver) system
  • FSK output
  • PTT and CW outputs
  • RS-485 port to connect external devices, such as antenna relays
  • Transceiver audio interface for operating digital modes, voice recording and playback
Transceiver connection
  • Single 25-pin connector for transceiver cable
  • Various transceiver models supported
Audio interface
  • Input/output samplerate: 8 to 48 kHz
  • Insulated from digital nets
  • Maximum input/output amplitude is 1V
  • True 16-bit DAC/ADC used
CAT serial port
  • Baudrate: 300-115200 baud
  • Electrical compatibility: RS-232, CI-V, TTL or inverted-TTL (Yaesu, Icom, Kenwood, Ten-Tec, Elecraft and JRC transceivers)
PTT/CW outputs
  • CW output: open collector
  • Maximum current is 50 mA
  • PTT output: open collector and TTL-level
FSK output
  • Baudrate: 45-1200 baud
  • Open collector output
Weight
  • 300 g
Note
  • Мade in Ukraine
More
Partners